【国外标准】 Standard Specification for Mortar, Refractory (High-Temperature, Air-Setting)

This specification covers dry air-setting refractory mortar for use in laying and bonding refractory brick in ship boiler furnaces and wet air-setting refractory mortar for use in laying refractory brick in stationary boiler furnaces, bright annealing furnaces, controlled atmosphere furnaces, and furnaces heated by electric elements. The refractory mortar shall be of the following types: Type 1 and Type 2. The mortar shall be composed of finely ground heat-resistant clays, minerals, or a mixture of clays and minerals in either a dry or wet condition. Fineness test, heat soak, and bonding strength test shall be performed to conform with the specified requirements.1.1 This specification covers dry air-setting refractory mortar for use in laying and bonding refractory brick in ship boiler furnaces and wet air-setting refractory mortar for use in laying refractory brick in stationary boiler furnaces, bright annealing furnaces, controlled atmosphere furnaces, and furnaces heated by electric elements.1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.